VW T4 1 pair of rear shock absorber reinforcement plates as a set for both left and right sides, version 1 (straight)

The VW T4 replacement reinforcement plates version 1 (straight) for the shock absorber mount on the rear axle are the perfect repair panels if your vehicle is suffering from rust damage in this important area. The replica reinforcement plates are made of 2 mm sheet metal and are significantly more robust than the original. They can be welded easily and safely, ensuring a perfect connection with the vehicle frame.

Galvanized

The VW T4 reinforcement plates are coated with a thin layer of zinc, providing ideal protection against rust and damage. After installation, you should completely seal the reinforcement plates with a 2K primer. Then, a proper stone chip protection should be applied.

Notes on the replica of the VW T4 reinforcement plates - straight

Please note that there is a "straight" version 1 without curves when replicating the reinforcement plates. Before ordering, you should check if the reinforcement on the reinforcement plate runs as shown in the picture on your VW T4. Version 2 with "curved" reinforcement is also available in this shop.

To ensure a safe and correct installation, speak to a technician from a certified testing center (e.g. TÜV, DEKRA, etc.) before installing the VW T4 reinforcement plates. The installation should only be carried out by professionally trained personnel (e.g. bodywork master workshop).

Stabilize your VW T4 on the rear axle

If the old reinforcement plates have rusted through, you can easily replace them with our reinforcement plates to give your vehicle more stability and durability again.