VW T4 Reinforcement Plates Shock Absorber Version 2 (curved) for Rear Left + Right

The VW T4 replica reinforcement plates Version 2 (curved) for the shock absorber mount on the rear axle are the perfect repair panels if your vehicle suffers from rust damage at this important point. The replica reinforcement plates are made of 3 mm steel sheet and are significantly stronger than the original. They can be welded easily and securely, ensuring a perfect connection with the vehicle frame.

Galvanized

The VW T4 reinforcement plates are coated with a thin layer of zinc, providing ideal protection against rust and damage. After installation, you should completely seal the reinforcement plates with a 2K primer. Then, a reasonable stone chip protection should be applied.

Instructions for replicating the VW T4 reinforcement plates - curved

Please note that there is a "curved" Version 2 with curves when replicating the reinforcement plates. Before ordering, you should check on your VW T4 if the stiffening on the reinforcement plate runs as shown in the picture. Version 1 with "straight" stiffening is also available in this shop.

To ensure that the VW T4 reinforcement plates can be installed quickly and easily, you should consult with a technician from a certified testing agency (such as TÜV, DEKRA, etc.) beforehand. The installation should only be carried out by trained personnel (such as a bodywork master workshop) to ensure safe and correct installation.

Stabilize your VW T4 at the rear axle

If the old reinforcement plates have rusted through, you can simply replace them with our reinforcement plates and give your vehicle more stability and longevity.